News Release

UPDATE: Castle Rock Cut and Antelope Point Marina Launch Ramp Fully Open

Subscribe RSS Icon | What is RSS
Date: June 21, 2019
Contact: Mary Plumb, 928-608-6202

As of June 21, 2019 the Antelope Point Marina Launch Ramp is fully open. The park wishes all visitors a safe and enjoyable boating season.



Date: June 14, 2019

Lake Powell boaters will welcome the good news that due to rising lake levels the Castle Rock Cut is now fully open to all vessels. The Castle Rock Cut is located about three miles due east of the Wahweap Developed Area, just over the Utah border between Wahweap Creek and Warm Creek Bays. The Castle Rock Cut is a short-cut route that allows boaters to conveniently travel between the Wahweap Marina and destinations uplake, shortening the uplake trip by approximately one hour (or 12 miles).

At Antelope Point Marina, park staff are working to install and adjust marine infrastructure to provide for boater safety and access.  Vessels up to 30 feet in length are now able to be launched from the east side of the launch ramp.

The kayak launching area is also open. Vehicles can still use the full width of the ramp for approaching the waterline but due to a severe drop-off will not be able to back into the west side of the ramp.

The park wishes all visitors a safe and enjoyable boating season.



Last updated: June 25, 2019

Park footer

Contact Info

Mailing Address:

PO Box 1507
Page, AZ 86040

Phone:

928 608-6200
Receptionist available at Glen Canyon Headquarters from 7 am to 4 pm MST, Monday through Friday. The phone is not monitored when the building is closed. If you are having an emergency, call 911 or hail National Park Service on Marine Band 16.

Contact Us